Table of Contents
Advertisement
6. Press [OK] to return to <Key in coord>. Set the
next setting out point to continue setting out
measurement.
15.4 REM Setting-out Measurement
To find a point where a target cannot be directly installed, perform REM setting-out measurement.
"12.5 REM Measurement"
PROCEDURE
1. Install a target directly below or directly above the
point to be found. Then use a measuring tape etc.
to measure the target height (height from the
survey point to the target).
2. Select "Setting out" in <Menu> to display <Setting
out>.
3. Set the instrument station, and, if necessary, enter
data for Backsight setup.
"15.2 Distance Setting-out Measurement"
steps 2 to 3
4. Select "SO data setting" In <Setting out> to
display <SO data setting>.
Press [Shvr] until the distance input mode is
"SO.Height.". Input height from the surveying point
to the position to be set out in "SO.Height". If
necessary, input the angle to the point to be set
out. Enter values and press [OK].
15. SETTING-OUT MEASUREMENT
93
Advertisement
Table of Contents
