Table of Contents
Advertisement
8. Set "Authentication" to "Yes" or "No".
If "Authentication" is set to "Yes", the passkey will
also need to be input on the companion device.
9. When "Authentication" is set to "Yes", input the
same passkey as that for the intended companion
device. Even if "Authentication" is set to "No", a
passkey is requested when authentication is set
on the companion device being used.
• Up to 16 numeral characters can be input. Input
characters will be displayed as asterisks (e.g.
"*****"). The passkey was set to "0123" at the
factory.
10.Press {Enter} to finish settings. Move on to the
Bluetooth communication.
"9.2 Communication between the iX and
Companion Device"
• When selecting "T-type" in step 3, the following items are displayed.
(1) REC Type
REC-A* (newly measured data is output)/REC-B (displayed data is output)
(2) Terminate
ETX*/ETX+CR/ETX+CR+LF
(3) TRK State
On (with track state information)/Off*
(4) Ack mode
On*/Off
Terminate
Select the option Off or On for carrige return (CR) and line feed when collecting measurement data with a
computer.
ACK mode
When communicating to an external device, the protocol for handshaking can omit the [ACK] coming from
the external device so data is not sent again.
On: Standard
Off: Omit the [ACK]
9. CONNECTING TO EXTERNAL DEVICES
38
Advertisement
Table of Contents
