Sokkia X-1000 series Operator's Manual page 86

5. If measuring two or more known points, repeat
procedures 4 in the same way from the second
point.
6. Press [CALC] or [YES] to automatically start
calculations after observations of all known points
are completed.
• Instrument station elevation and standard
deviation, which describes the measurement
accuracy, are displayed in <Result>.
Standard deviation values for each point are
displayed in <Detail>.
7. If there are problems with the results of a point,
align the cursor with that point and press [OMIT].
"OMIT" is displayed to the right of the point.
Repeat for all results that include problems.
8. Press [RE CALC] to perform calculation again
without the point designated in step 7 The result is
displayed.
If there are no problems with the result, go to step
9.
If problems with the result occur again, perform the
resection measurement from step 4.
82
14. RESECTION MEASUREMENT