Table of Contents
Advertisement
• As for the download and install of "exFat file system driver"/ActiveSync/Windows Mobile Device Center,
please access to Microsoft support site.
PROCEDURE Connecting the instrument to a computer to transfer data from instrument in USB
mode
1. Slide up the catch on the external interface hatch
to open.
2. Power OFF the instrument. Connect the USB port
2 on the instrument and computer using the USB
cable.
"8. POWER ON/OFF"
• The computer does not need to be turned OFF
before connection.
3. Press the power key on the side of the instrument
while pressing {Enter} to display a message box
asking whether to boot USB mode, then press
[YES].
The screen of the instrument will be <USB Mode>.
• instrument may not be displayed as <Removable
Disk>. It depends on Windows settings.
Follow the instructions below to ensure that the
instrument continues to operate normally during
USB transfer.
• Do not change the folder hierarchy or folder
names in <Removable Disk>.
• Do not format the "removable disk" on the
computer.
4. Perform "Safely Remove Hardware"
task bar and disconnect the USB cable.
5. Press the power key and hold (about 1sec) to turn
off the instrument to exit USB mode connection.
USB port 2
in the
48
9. CONNECTING TO EXTERNAL DEVICES
Advertisement
Table of Contents
