Changing Starkey Mode Icons - Sokkia X-1000 series Operator's Manual

7. Press {ESC} to finish allocating icons. The
allocated icons are stored in memory and the
previous screen is restored. The newly allocated
icons appear in the relevant measurement screen.

19.13 Changing Starkey Mode Icons

It is possible to preset icon allocations of the Starkey mode to suit various applications and the ways that
different operators handle the instrument.
• The current icon allocations are retained until they are revised again, even when the power is turned off.
• Press [CLEAR] in <Customize/Select screen> in "19.13 Changing Starkey Mode Icons" " PROCEDURE
Changing Starkey icon allocations" step 2 to return all customized configurations including screen controls
and Operating icon allocations to their previous settings.

• When icon allocations are recorded and registered, the previously recorded settings are cleared.
• When the upper 8 icons' allocations are recorded and registered, the setting reflects to Status icon.
Icons that can be allocated to the Status icon

Remaining battery power
Target display
Motor
Laser-pointer/guide light
Tilt angle compensation
Communication status
Input mode
SIP (Input panel)
ppm (atmospheric correction factor)
Internet communication status
Touch panel
Disk
No icon
PROCEDURE Changing Starkey icon allocations
1. Select "Customize" to display <Customize/Select
screen>.
128
19. CHANGING THE SETTINGS