HP 16554A Programmer's Manual page 300

DATA and SETup Commands
SYSTem:SETup
Additionally, the following sections may also be included, depending on what
is available:
"SYMBOLS A "
"SYMBOLS B "
"INVASM A
"INVASM B
<block data> <block length specifier><section>...
<block length #8<length>
specifier
the total length of all sections in byte format (must be represented with 8
<length>
digits)
<section> <section header><section data>
16 bytes in the following format:
<section
10 bytes for the section name
header>
1 byte reserved
1 byte for the module ID code (34 for the HP 16554A and HP 16555A/D
4 bytes for the length of the section data in bytes
format depends on the type of data. The total length of a section is 16 (for
<section data>
the section header) plus the length of the section data. So when calculating
the value for
headers. The format of the setup block is not affected by the DBLock
command setting.
Example
OUTPUT XXX;"SETUP" <block data>
Query
:SYStem:SETup?
The SYStem:SETup query returns a block of data that contains the current
configuration to the controller.
Returned Format
[:SYStem:SETup] <block data><NL>
17–14
"
"
logic analyzer)
, don't forget to include the length of the section
<length>