Plus - HP 16554A Programmer's Manual

PLUS

Command :WLISt:PLUS <module_spec>,<waveform>,<waveform>
The PLUS command inserts time-correlated A+B oscilloscope waveforms on
the screen. The first parameter specifies which slot is the oscilloscope
module. 1 through 10 refers to slots A through J. The next two parameters
specify which waveforms will be added to each other.
PLUS only inserts oscilloscope waveforms. It cannot be used with analyzer
waveforms.
{1|2|3|4|5|6|7|8|9|10} (slot where master card is located)
<module_spec>
string containing <acquisition_spec>{1|2}
<waveform>
{A|B|C|D|E|F|G|H|I|J} (slot where acquisition card is located)
<acquisition_
spec>
Example
OUTPUT XXX; ":WLIST:PLUS 1,'A1','A2'"
WLISt Subsystem
PLUS
4–11