Table of Contents
Advertisement
Introduction
The commands in the State Waveform subsystem allow you to
configure the display so that you can view state data as waveforms. Up
to 96 channels, identified by label name and bit number, can be
displayed at a time. The 12 commands in this subsystem are
analogous to their counterparts in the Timing Waveform subsystem.
In this subsystem the X axis is restricted to representing only samples
(states), regardless of whether time tagging is on or off. As a result,
the only commands which can be used for scaling are DELay and
RANge.
The way to manipulate the X and O markers on the Waveform display
is through the State Listing (SLISt) subsystem. Using the marker
commands from the SLISt subsystem will affect the markers on the
Waveform display.
The commands in the SWAVeform subsystem are:
•
ACCumulate
•
ACQuisition
•
CENter
•
CLRPattern
•
CLRStat
•
DELay
•
INSert
•
MLENgth
•
RANGe
•
REMove
•
TAKenbranch
•
TPOSition
8–2
Advertisement
Table of Contents
