AMX Vision 2 Operation/Reference Manual page 60

Accessing Servers
8.
Access the server's Vision
information.
9.
Change the Master Server Name to the Master R710 server's name (FIG. 49).
FIG. 49 Vision
10.
Click Apply, and restart the application. You can now control this server via the Main Master server.
You have now successfully added a new server. On the remote server, you must change the Master Server
Name in the Vision
If an incorrect server name is entered the system will attempt the connection for 30
seconds and then if unsuccessful the following error message will appear. Click OK,
and click Add New Server again.
50
2
application. See the Accessing the Server section on page 48 for more
2
Server application
2
application to the Master Server and restart the application.
Change the Master server name
2
Vision Operation/Reference Guide