Table of Contents
Advertisement
ASX-112FR Autosampler Operator's Manual
Chapter 3: Installing the Autosampler
Mounting the Sample Probe Assembly
Mounting the sample probe assembly on the autosampler is the first task in
assembling the ASX-112FR. However, prior to mounting the probe, the
installation of the Y-arm should be confirmed to be compatible with the height
of the racks intended for use.
Figure 3-1 shows three sets of mounting holes provided for height options for
the Y-arm. If the autosampler is intended to run with half Bel-Art racks and
tall standards in the tall configuration, make sure the Y-arm is mounted in the
top most mounting location. If the autosampler is intended to run with the
CETAC short racks and short standards in the short configuration, make sure
the Y-arm is mounted in the center or short mounting position (see Figure
3-1).
Tall Mounting Position
Center Mounting Position
Short Mounting Position
Figure 3-1. Y-Arm Mounting Positions.
20
Advertisement
Table of Contents
