Connecting The Autosampler To The Power Supply - Teledyne CETAC ASX-112FR Operator's Manual

Connecting the Autosampler to the Power Supply

The autosampler is powered by the supplied external desktop "brick" power
supply. Ensure that you position the autosampler so that the location where
the power supply cord plugs into it is easily accessible (is not blocked) and it
can be quickly disconnected if needed. In case of hazard, the system should be
disconnected from the power source.
Turn the power switch on the autosampler OFF.
1
Check the plug on the power cord to verify that it is of the correct type for your
country.
2
Plug the power cord into a power outlet.
3
Plug the power cord into the power supply.
4
To POWER
Connector on
Figure 3-14 Desktop "Brick" Power Supply
Autosampler
Plug the power supply into the 24V connector on back of the autosampler.
5
Turn the power switch on the front of the autosampler ON.
6
It is important to use the appropriate power cord for your country. See
 "Power requirements" on page 78.
 "Power Cord Set Requirements" on page 79.
FIRE AND SHOCK HAZARD
WARNING
Use only the provided desktop power supply. The power supply must be
plugged into an outlet which has a protective ground connection.
ASX-112FR Autosamplers Operator's Manual
Chapter 3: Installing the Autosampler
Power Cord to
Grounded AC Power
Outlet
35