Table of Contents
Advertisement
conductors and ground. A protective ground connection by way of the
grounding connector in the power cord is required for safe operation.
Ensure that you position the autosampler so that the location where the power
supply cord plugs into it is easily accessible (is not blocked) and it can be
quickly disconnected if needed. In case of hazard, the autosampler should be
disconnected from the power source.
The power supply socket is on the back of the autosampler (see Figure 1-4 on
page 11). Connect the power supply to the autosampler first and then connect
a line cord to the power supply. Do not apply power to the power supply until
ready to operate the autosampler.
Unpacking the Autosampler
LIFTING HAZARD
WARNING
The autosampler may be awkward to lift. Incorrect lifting technique may
Inspect external packaging upon receipt for signs of shipping damage. Inspect
cause personal injury. Use caution when lifting the autosampler.
all items during unpacking and notify the carrier immediately of any concealed
damage. Check for any kinked or bent tubing.
If the system is shipped or removed from storage during cold weather, allow
the packaged equipment to equilibrate to room temperature before opening
and exposing to warm, humid air. It is usually sufficient to provide four to eight
hours for this purpose.
EQUIPMENT DAMAGE FROM CONDENSATION
CAUTION
If condensation forms on or inside the autosampler, allow it to dry thoroughly
before connecting it to a power source and operating it. Failure to do so may cause
Remove the packing checklist from the shipping container, and check off items
equipment damage.
against it. Leave accessories in the packing until you are ready to install them.
NOTE
Keep the factory packaging for use in case the product ever needs to be
returned or shipped to another location.
ASX-112FR Autosamplers Operator's Manual
Chapter 2: Preparing for Installation
17
Advertisement
Table of Contents
