Using Hyperterminal; Setting Preferences - Teledyne CETAC ASX-112FR Operator's Manual

ASX-112FR Autosampler Operator's Manual
Chapter 8: Operating a CETAC Autosampler Using a Terminal Program
The window will close and the settings will be saved. These new settings
will be applied immediately and used thereafter unless changed again.
NOTE
Except for the ASX-8000, all CETAC devices communicate at 9600 baud (which is
the default.)
NOTE
Only installed COM ports, including USB virtual COM ports, will appear in the
Comm Port menu.
If desired, the size of the scrollback buffer or the color of the outgoing and

Setting Preferences

incoming texts can be changed (in case of color blindness, for example).
On the Tools menu, click Preferences.
1
Figure 8-5 Preferences Window
To change the Scrollback Buffer Length, either type the new value in the
field or use the arrows to adjust the value up or down.
To change text color, click on the color bar and a color selection dialog box
will appear. Select the new color and click OK.
Click Save to apply your settings and close the window.
2

Using HyperTerminal

Using a serial cable, connect the CETAC autosampler with the host computer.
Plug each end of the serial cable into the COM 1 port of the autosampler and
1
the corresponding COM port of the host computer, respectively.
Turn on the host computer and select the Accessories folder. Select the
HyperTerminal folder and then the HyperTerminal program.
2
72