Autosampler Configuration Options - Teledyne CETAC ASX-112FR Operator's Manual

ASX-112FR Autosampler Operator's Manual
Chapter 1: Introduction
of chemistry, a basic knowledge of electronic sampling equipment, at least a
beginning level of computer experience, and working knowledge of the
analytical instrument used with the autosampler.
CHEMICAL INJURY HAZARD
WARNING
The autosampler is intended for use only by qualified operators who have
been trained in safe laboratory practices. Make sure you know the hazards
associated with all of the chemicals you are using, and take the appropriate
precautions. Exposure to laboratory chemicals may result in serious injury.

Autosampler Configuration Options

The ASX-112FR is very configurable making it ideal for use in multiple
applications. Three models are available. The standard model comes with a
polypropylene rinse station controlled by a peristaltic pump. A second model
comes with a polypropylene rinse station controlled by a gas displacement
pump, which uses compressed gas to push the rinse solutions through the
rinse station. A third model is equipped with a PFA rinse station and a gas
displacement pump for ultra-clean applications.
All three models have the option to be selected in either a tall or short
configuration. The height configuration restricts the choice of racks to be
either tall—BelArt half racks (with 7 mL or 14 mL vials) or short—CETAC
racks for small samples (with 0.5 mL, 1.0 mL, 1.5 mL or 2 mL vials). The rinse
station is also configured in either a tall or short version.
Three probe sizes are offered: 0.010" (0.25 mm), 0.010" (0.25 mm) ID, and
0.035" (0.89 mm) ID. The 0.035" ID is expected to be the standard with the
0.010" ID designed for a low-flow (<0.5 mL/min) nebulizer. If the ASX-112FR
is used with the CETAC Aridus II™ or Aridus3 system, then the uptake line of
the C-Flow PFA nebulizer is typically used as the sample probe in a self-
aspiration mode.
Spares kits are available to convert a tall model into a short model, and vice
versa. Optional rack kits are also available as spares.
The front of the ASX-112FR is shown in Figure 1-1.
8