Table of Contents
Advertisement
4 Verifying Installation
Once installation of the autosampler is complete, it is important to verify that
you have installed it correctly. Attempting to use it before ensuring that it is
installed correctly may result in damage to the autosampler.
Verifying installation of the autosampler consists of two parts:
Ensuring that the communications interface between it and the host
computer is working.
Ensuring that the sample probe functions properly.
This chapter explains how to test the above items before using the
autosampler.
NOTE:
The procedures given in this chapter are for use in a Windows XP environment.
Testing the Communications Interface
If the communications interface between the autosampler and the host
computer is not established correctly, the autosampler will not function.
Check that the communication cables are properly attached between the host
computer and the autosampler.
1
Turn on power to the autosampler.
2
Connect to the autosampler using the host ICP-MS software or a terminal
emulator program such as C-Term.
3
See "Operating a CETAC Autosampler Using a Terminal Program" on page 69
then continue with step 4.
Enter the HOME command.
4
The autosampler should reset, with the Y-arm moving out and back into the
home position and the rotary tray moving out and back into home position. If
the autosampler does not reset, see "Troubleshooting the Autosampler" on
page 63.
43
Advertisement
Table of Contents
