Table of Contents
Advertisement
Section 1 – Assembly Instructions
Flodex Operation Manual—21-101-000 Rev. E—18 June 2019
Section 1 – Assembly Instructions
(See Figure 1 – Flodex final assembly
1.
Insert the mounting post (2) into the base (1) while
simultaneously inserting the shaft of the cylinder
assembly (3) into the mounting post. Do not tighten
the set screws.
2.
Gently rotate the mounting post into the base until
the cylinder assembly is approximately in the center
of the base. Then, tighten the screws (9) in the
base.
3.
Lightly tighten the cap screw (6) holding the cylinder
assembly shaft to keep the cylinder assembly
centered in place while continuing assembly.
4.
Push the funnel ring stand (5) over the mounting
post and into the approximate position shown. Then
loosen the cap screw (6), hold the cylinder assembly
shaft, and slide the cylinder assembly in or out until
the center of the cylinder exactly lines up with the
bottom of the funnel. Tighten the screw holding the
cylinder assembly shaft. Be sure the cylinder is
vertically in line with the shaft (2) before tightening
the screw.
5 of 17
Advertisement
Table of Contents
