Table of Contents
Advertisement
Chapter 8: Operating a CETAC Autosampler Using a Terminal Program
Figure 8-3 Outgoing commands shown in green and incoming responses
shown in red
By default, C-Term attempts to open COM1 the first time it is executed. If the
Configuring C-Term
COM port that the CETAC device is connected to is not the default (COM1), then
it will be necessary to configure C-Term to use the desired port.
The default communications configuration is appropriate for use with the vast
majority of CETAC devices. Exceptions are the ASX-8000 which requires a baud
rate change and the AS300 emulator which uses non-printing characters as
part of its command protocol. Modifying the default settings is described
below.
NOTE
If COM1 (or the currently selected COM port) is in use by another program or is
otherwise unavailable, a warning dialog box will pop up when C-Term starts
stating that the COM port could not be opened.
On the Tools menu, click Setup Serial Port.
1
Figure 8-4 Serial Port Setup Window
Select the desired COM port and, if necessary, the Baud rate used by the
connected device then click OK.
2
ASX-112FR Autosamplers Operator's Manual
71
Advertisement
Table of Contents
