Lacp Priority Settings; Figure 22: L2 Switching > Link Aggregation > Lag Port Settings; Figure 23: L2 Switching > Link Aggregation > Lacp Priority Settings; Table 19: Lag Port Settings - Allied Telesis IS230-10GP Web User Manual

Chapter 2: Managing Switch
Item
LAG Select
Enabled
Speed
Flow Control
Apply
Item
System Priority
Apply
50
Figure 22. L2 Switching > Link Aggregation > LAG Port Settings
The following table describes the items in Figure 22.
Table 19. LAG Port Settings
Description
Click the drop-down menu to select a predefined LAG trunk definition:
LAG 1-8.
Click the radio button to enable or disable the LAG Port.
Click the drop-down menu to select the port speed: Auto, Auto-10M,
Auto-100M, Auto-1000M, Auto-10/100M, 10M, 100M, or 1000M.
Click the radio button to enable or disable the Flow Control for the
LAG Port.
Click Apply to save the values and update the screen.
The LAG Port Status settings in the ensuing table are informational only:
LAG, Description, Port Type, Enable State, Link Status, Speed, Duplex,
FlowCtrl Config and FlowCtrl Status.

LACP Priority Settings

The LACP Priority Settings page allows you to configure the system
priority for LACP.
To access this page, click L2 Switching > Link Aggregation > LACP
Priority Settings.
Figure 23. L2 Switching > Link Aggregation > LACP Priority Settings
The following table describes the items in Figure 23.
Table 20. LACP Priority Settings
Description
Enter the value (1-65535) to designate the LACP system priority.
Click Apply to save the values and update the screen.
The LACP Information settings in the ensuing table are informational
only: System Priority.