Configuring The Ethernet Ports - Allied Telesis IS230-10GP Web User Manual

Configuring the
Ethernet Ports
The switch comes with default port settings that should allow you to
connect to the Ethernet Ports with out any necessary configuration.
Should there be a need to change the name of the ports, negotiation
settings or flow control settings, you can do this in the Port Configuration
menu. Access this menu by selecting Setup from the Main menu, and then
selecting Main Settings.
Port Name: Each port in the managed switch can be identified with a

custom name. Specify a name for each port here.
Admin: Ports can be enabled or disabled in the managed switch. For

ports that are disabled, they are virtually non-existent (not visible in
terms of switch operation or spanning tree algorithm). Choose to
enable or disable a port by selecting Enabled or Disabled, respectively.
Negotiation: All copper ports and gigabit fiber ports in the managed

switch are capable of autonegotiation such that the fastest bandwidth
is selected. Choose to enable auto-negotiation or use fixed settings.
100Mbps Fiber ports are Fixed speed only.
Speed/Duplex/Flow Control: The managed switch accepts three local

area network Ethernet Standards. The first standard, 10BASE-T, runs
10Mbps with twisted pair Ethernet cable between network interfaces.
The second local area network standard is 100BASE-T, which runs at
100Mbps over the same twisted pair Ethernet cable. Lastly, there is
100BASE-F, which enables fast Ethernet (100Mbps) over fiber.
These options are available:
10h–10 Mbps, Half Duplex

10f –10 Mbps, Full Duplex

100h–100 Mbps, Half Duplex

100f –100 Mbps, Full Duplex

1000f–1000 Mbps, Full Duplex

The gigabit combination ports have two rows, a standard row of check
boxes and a row labeled "SFP" with radio buttons. The SFP setting
independently sets the speed at which a transceiver will operate if one is
plugged in. Otherwise, the switch will use the fixed Ethernet port and the
corresponding settings for it.
Note
When 100f is selected for the SFP port, the corresponding fixed
Ethernet jack will be disabled unless it is changed back to 1000F.
IS230-10GP Industrial layer 2 Switch Web User Guide
25