Network Port; Figure 17: System > Network Port - Allied Telesis IS230-10GP Web User Manual

Chapter 2: Managing Switch
Item
SNTP Port
Manual Time
Time Zone
Daylight Saving Time Click the drop-down menu to enable or disable the daylight saving
Daylight Saving Time
Offset
Recurring From
Recurring To
Non-Recurring From Click the drop-down menu to designate a start date and time for a
Non-Recurring To
Apply

Network Port

44
Table 13. System Time (Continued)
Description
Enter the port on the server to which SNTP requests are to be sent.
Allowed range is 1 to 65535 (default: 123).
Click the drop-down menus to set local date and time of the system.
Click the drop-down menu to select a system time zone.
time settings.
Enter the offsetting variable in seconds to adjust for daylight saving
time.
Click the drop-down menu to designate the start date and time for
daylight saving time.
Click the drop-down menu to designate the end date and time for day-
light saving time.
non-recurring daylight saving time event.
Click the drop-down menu to designate the end date and time for a
non-recurring daylight saving time event.
Click Apply to save the values and update the screen.
The System Time Information settings in the ensuing table are
informational only: Current Date/Time, SNTP, SNTP Server Address,
SNTP Server Port, Time zone, Daylight Saving Time, Daylight Saving
Time Offset, From and To.
The Network Port page allows you to select ports that are detected by the
loopback detection function and configure their status (enabled or
disabled).
To access this page, click System >
Figure 17. System > Network Port
Network Port
.