Port Settings; Figure 56: L2 Switching > Loopback Detection > Port Settings; Table 52: Loopback Detection Global Settings; Table 53: Loopback Detection Port Settings - Allied Telesis IS230-10GP Web User Manual

Chapter 2: Managing Switch
Item
State
Interval
Recover Time
Apply
Item
Port Select
Enabled
Apply
76
The following table describes the items in Figure 55 on page 75.
Table 52. Loopback Detection Global Settings
Description
Select Enabled or Disabled to setup the loopback mode.
Enter the variable in seconds (1 to 32767) to set the interval at which
frames are transmitted.
Enter the variable in seconds (60 to 1000000) to define the delay
before recovery.
Click Apply to save the values and update the screen.
The Loopback Detection Global Information settings in the ensuing
table are informational only: State, Interval and Recover Time.

Port Settings

The Port Settings page allows you to select ports that are detected by the
loopback detection function and configure their status (enabled or
disabled).
To access this page, click L2 Switching > Loopback Detection > Port
Settings.
Figure 56. L2 Switching > Loopback Detection > Port Settings
The following table describes the items in Figure 56.
Table 53. Loopback Detection Port Settings
Description
Enter the port to define the local loopback detection setting.
Select Enabled or Disabled to setup the Loopback Detection func-
tion.
Click Apply to save the values and update the screen.
The Loopback Detection Port Information settings in the ensuing table
are informational only: Port, Enable State and Loop Status.