Figure 6-3 Cover Plate - Overland Data DLT LibraryXpress Series Service Manual

Replacement
Refer to Figure 6-3.
1. Place the cover plate on top of the module so that it overhangs one-half inch at the
rear.
2. Slide the cover plate toward the front of the module until it touches the front panel.
3. Tighten the captive screw near the center of the cover plate.
4. At the rack, pull the intermediate slides for the removed module outward until they
lock in the extended position.
5. Note: This step should be performed by two people, one on each side of the module.
Lift the module from the work surface and move it to the front of the rack. Lift the
module to its installed height. Engage the inner slides mounted on the module with
the intermediate slides protruding from the rack. Slide the module toward the rack
until the inner slide lock on each side engages the internal slide. This leaves the
module protruding from the rack, locked in position, supported by slides.
Chapter 6 - Parts Removal and Replacement
Figure 6-3 Cover Plate
89