Table of Contents
Advertisement
Figure 2-5
4.
Refer to Table 2-1 for the required belt length for your system. After double-
checking the length specified, cut the belt between teeth.
5.
With the toothed side of the belt toward you, position the right end of the belt about
halfway along the XpressChannel.
6.
Referring to Figure 2-5, thread the left end of the belt counter-clockwise around the
motor drive pulley.
7.
Referring to Figure 2-6, thread the belt from the motor drive counter-clockwise
around the idler pulley and back to the right end.
8.
Holding the ends of the belt as shown in Figure 2-7, the two ends should be touching
or very slightly overlapping.
20
Threading the Belt Through the Drive Section
Chapter 2 - Installation
Advertisement
Table of Contents
Troubleshooting
