Loading And Unloading Tapes; Figure 3-23 Error Historys; Figure 3-24 Default Screen; Figure 3-25 Main Menu - Overland Data DLT LibraryXpress Series Service Manual

1. At the Default Screen, press the
Menu is displayed.
2. At the Main Menu, press the
to 'Show History Menu.'
3. Press the
4. At the Show History Submenu, press the
is next to 'Error History.'
5. Press the
displayed in the format shown in Figure 3-23.
6. Using the

Loading and Unloading Tapes

The Load/Unload menus enable you to specify a source and a destination for a cartridge
movement. As a result, you use exactly the same procedure to load and unload. To load or
unload a tape from the front panel of the module, use the Load/Unload menus as follows.
A default screen is shown in Figure 3-24. From the Default Screen, enter the Menu Mode by
pressing the
Enter
62
Ente
button four times until the
button to select the submenu.
Enter
button to select the function. A circular list of 4-line error reports is
Enter
Fault Code: XXXX
Error Description
DD/MMM/YYYY HH:MM:SS
Entry NNNN Of NNNN
Figure 3-23 Error History Screen
and buttons, scroll the list to display the error history of the module.
READY
Modules 123456
1
_ _ _ _ _ _ _ _
11 16
_ _ _ _
Figure 3-24
button. The Main Menu shown in Figure 3-25 appears.
Load/Unload
Show Status Menu
Maintenance Menu
Configure Menu
Figure 3-25
r button to enter the Menu Mode. The Main
button once so that the
__
10
Default Screen
Main Menu
in the display is next
in the display
Chapter 3 - Operation