Fault Symptom Codes (Fsc) - Overland Data DLT LibraryXpress Series Service Manual

Fault Symptom Codes (FSC)

Fault Symptom Codes appear in the Fault Screen described in Chapter 3 - Operation. Each
FSC is accompanied by a descriptive message and instructions for clearing the fault. When a
fault persists, the operator should look up the FSC in Table 5-2 to determine the error
recovery procedure to be followed. If you call your Technical Support representative about a
fault condition, be sure to furnish the FSC to aid in identifying the problem.
age is displayed that is not included in Table 5-2, please write down the fault
If an error mess
code number and follow the recovery procedure described on line 4 of the display. If the same
error occurs again, call your technical support representative.
Chapter 5 - Troubleshooting
Table 5-2 Fault Symptom Codes
FSC Displayed Message
3001 Picker Tries Excd
Power Down to Clear
3002 Picker Tach Errors
Power Down to Clear
3003 Elevator Tach Errors
Power Down to Clear
3004 Elevator Jammed
Power Down to Clear
3005 Picker Jammed
Power Down to Clear
5002 All DLTs/Slots Empty
Press Enter to Clear
5003 All DLTs/Slots Full
Press Enter to Clear
5012 All Drives Full
Press Enter to Clear
5014 DLT Already Loaded
Press Enter to Clear
5015 Expired Clean'g Cart
Press Enter to Clear
5016 Not a Clean'g Cart
Press Enter to Clear
5020 All DLTs/Slots Empty
Press Enter to Clear
ERP
C, D,
G
D, G
D, G
C, D,
G
C, D,
G
F
F
F
F
F
F
F
81