Magazine Opto Sensor
Removal
Refer to Figure 6-16.
1.
Remove the cover plate as described in this chapter.
2.
Remove the Power Supply Assembly as described in this chapter.
3.
Move the shuttle toward the back of the chassis so the area to the left of the door is
accessible.
4.
Disconnect the Magazine Opto Sensor J19 from the Controller PWB.
5.
Remove the six M3 x 12 mm flat head Phillips screws that hold the magazine track
in place. Guide the Magazine Opto Sensor cable through the opening at the rear of
the bulkhead.
6.
Remove the two M3 x 8 mm screws and sems washers that hold the opto sensor to
the magazine track.
110
Figure 6-16
Magazine Track and Sensor
Chapter 6 - Parts Removal and Replacement