Chapter 6 - Parts Removal And Replacement - Overland Data DLT LibraryXpress Series Service Manual

Chapter 6 - Parts Removal and Replacement

This chapter describes how to remove and replace parts of the DLT Library Express Global
Control, Capacity, and Base Modules, as well as parts which must be removed to gain access
to them. Figure 6-1 shows the locations of many of these parts. In addition to FRUs,
instructions for accessing internal components by removing skin panels and access plates for
the desktop and rack mount configurations follow in the next section.
The parts of the LibraryXpress Modules that are listed below can be replaced in the field. Part
numbers are listed in Appendix B. The operations described in this chapter are intended to be
performed by qualified Customer Engineers. If you do not have such experience and training,
you should not attempt to replace any of these components except when directed to do so by
your technical support representative.
•
Bar-code Reader Assembly
•
Control Panel Assembly
•
Door Assembly
•
Fan Assembly
•
Leadscrew Assembly
•
Magazine Door Opto Sensor
•
Magazine Security Lock
•
Power Switch
•
Shuttle Cable Assembly
Chapter 6 - Parts Removal and Replacement
REPLACEABLE PARTS
•
Drive Caddy Assembly
•
Controller PWB Assembly
•
Door Opener/Magazine Lock Assembly
•
Front Panel Assembly
•
Magazine Door Assembly
•
Magazine Opto Sensor
•
Power Supply Assembly
•
Shuttle Assembly
•
Shuttle Motor Assembly
85