Figure 6-5 Drive Caddy - Overland Data DLT LibraryXpress Series Service Manual

Refer to Figure 6-5.
1. Remove the cover plate as described in this chapter.
2. Disconnect the SCSI cable connectors (1) from the Controller SCSI extension cable.
3. Disconnect the drive power "Y" cable (2) from the Power Supply connector.
4. Disconnect the Drive 1 and Drive 2 (if present) RS-422 cables (3) at the drives.
Remove the cables from under the cable clamps and lift them clear of the caddy.
5. Remove two M4 x 8 mm flat head Phillips screws (4) along the upper edge of the
Caddy Assembly.
6. Remove two M4 extension screws (5) at the top of the Caddy Assembly.
7. See the important note above. Lift the Caddy Assembly out of the chassis.
8. The DLT drives (6) may be removed from the caddy if desired, by removing four 6-
32 screws holding each drive at the top and bottom of the caddy.
Chapter 6 - Parts Removal and Replacement
Figure 6-5 Drive Caddy
93