Figure 6-10 Fan Assembly , Base - Overland Data DLT LibraryXpress Series Service Manual

7. Pull the fan cable toward the fan while guiding the connector under the drive caddy
platform. Remove the fan from the chassis. Discard the screws and retainers.
Replacement, Base Module
Refer to Figure 6-10.
1. Orient the fan inside the rear of the chassis so that the label is visible through the
vent holes in the chassis and so that the fan power cable is at the bottom.
2. Insert the fan power cable connector underneath the drive caddy platform, and push
on the cable until the connector emerges inside the electronics compartment.
3. While holding the fan in place, push four new plastic retainers into the chassis holes
from the outside. Be sure that the fan power cable is not pinched between the fan
and the chassis. Insert and tighten four plastic screws.
4. Connect the fan power connector to the mating connector from the power supply.
5. Replace the Power Supply Assembly as described in this chapter.
6. Replace the Drive Caddy as described in this chapter.
7. Replace the cover plate as described in this chapter.
102
Figure 6-10 Fan Assembly, Base Module
Chapter 6 - Parts Removal and Replacement