Figure 3-3 Base Module Control - Overland Data DLT LibraryXpress Series Service Manual

Base Module Indicators
There are four LED indicators on the control panel, labeled
(yellow),
Drive Fault
The indicator (green) is illuminated when the Base Module is ready to accept
Ready
commands, either from the Control Panel or from the host computer via the Global Control
Module. The
Ready
The LED (yellow) indicates that either or both drives require cleaning. A cleaning
Use Cleaner
operation should be performed as described in Chapter 4 - Maintenance. When the
LED comes on, you can find out which drive needs cleaning by selecting Cleaning
Cleaner
Needed on the Drive Status submenu.
When either the
Drive Fault
appears on the LCD display. The Fault Screen is described later in this chapter. A list of fault
symptom codes (FSC) and error recovery procedures (ERP) appears in Chapter 5 -
Troubleshooting.
Capacity Module Indicators
There are three LED indicators on the control panel, labeled
and (red).
Fault
The indicator (green) is illuminated when the system is ready to accept commands,
Ready
either from the Control Panel or from the host computer via the Global Control Module. The
indicator goes out when you enter the Menu Mode.
Ready
The LED (yellow) performs no function in this module.
Alert
When the LED (red) is illuminated, a Fault Screen appears on the LCD display. The
Fault
Fault Screen is described later in this chapter. A list of fault symptom codes (FSC) and error
recovery procedures (ERP) appears in Chapter 5 - Troubleshooting.
Chapter 3 - Operation
Figure 3-3 Base Module Control Panel
(red), and
Loader Fault
indicator goes out when you enter the Menu Mode.
or the
Loader Fault
(green),
Ready
(red).
LED (red) is illuminated, a Fault Screen
(green),
Ready
Use Cleaner
Use
(yellow),
Alert
47