Figure 6-20 Power Supplya - Overland Data DLT LibraryXpress Series Service Manual

Figure 6-20
Replacement - Early Production
Refer to Figure 6-20.
1. Rest the Power Supply Assembly on the center strut with the cables toward the front
of the chassis.
2. Connect the ring lug on the power switch cable to the ground post in the bottom of
the chassis. Install the M4 external star keps nut above and the #8 external tooth
star washer below the ring lug.
3. Connect the four spade lugs at the front panel AC power switch. Refer to the inset
in Figure 6-20 for orientation of the colors.
4. Connect the two white 6-pin electronics power connectors at the bottom of the
Controller Assembly PWB. Orient the connectors so the four black wires are
adjacent, and the polarization keys are downward.
5. Connect the small white 4-pin fan power connector at the floor of the chassis near
the caddy.
6. Connect the large white 4-pin drive power connector at the Drive Caddy.
7. Move the Power Supply Assembly toward its proper location while dressing the
power output cables underneath it and toward the rear of the chassis.
118
Power Supply Assembly, Early Production
Chapter 6 - Parts Removal and Replacement