Figure 2-4 Xpresschannel Assembled - Overland Data DLT LibraryXpress Series Service Manual

5. Place pairs of tie bars so that they straddle all of the joints where sections come
together. Be sure that the beveled edge is toward the inside corner of the sections.
6. Install two M3 x 20 mm Phillips sems screws through each tie bar into the threaded
holes in the flanges of the extrusion sections. Tighten finger tight only. Insert two
M3 x 20 mm Phillips sems screws through each tie bar into the side of the extrusion
sections and finger tighten.
18
Figure 2-4 XpressChannel Assembled
Chapter 2 - Installation