Emergency Magazine Removal; Inserting Cartridges Into The Magazine; Figure 3-34 Security Menu; Figure 3-35 Unlock All Media - Overland Data DLT LibraryXpress Series Service Manual

4. Press the
5. Press the
button. The display will appear as follows.
Enter
6. When the words 'In Progress' disappear, press the
the Default Screen appears.
7. Press the
not unlock, be sure that the key lock on the Module's front panel is unlocked.
8. When the 'Door Open' message flashes, grasp the handle, and pull the magazine
from the module.

Emergency Magazine Removal

If a fault occurs that prevents removal of the magazine, turn the power off for five seconds.
Power up while continuously pressing the
indicators on the control panel light, then go out. Release the button. The magazine may now
be removed.
If you are unsuccessful in removing the magazine using this procedure, refer to the section
titled 'Cartridge Magazine Removal' in Chapter 6 - Parts Removal and Replacement for
alternate procedures.

Inserting Cartridges Into the Magazine

A full magazine is shown in Figure 3-36. Insert cartridges so that the label end with the write
protect switch is outward, with the write protect switch toward the bottom of the magazine.
The lowest numbered cartridge slot in the magazine is closest to the handle
Chapter 3 - Operation
button to select the Security Menu, shown in Figure 3-34.
Enter
Unlock All Panels
Unlock All Media
Lock All Panels
Lock All Media
Figure 3-34
button once to move the
Unlock All Media
In Progress
Figure 3-35 Unlock All Media Screen
Button on the front panel of the Module. If the module does
Unlock/Open
π
Security Menu
next to 'Unlock All Media', then press the
Escape
button. Continue to hold the button until all of the
button repeatedly until
67