Figure 6-9 Door Opener /Magazine - Overland Data DLT LibraryXpress Series Service Manual

Figure 6-9
Replacement
Refer to Figure 6-9.
Note: The two sections of the Door Opener/Magazine Lock Assembly shown in figure 6-9
(the door opener bracket and associated parts, and the motor bracket and associated parts) are
supplied as a factory-adjusted matched pair. Do not mix old and new parts.
1. Locate the end of the motor cable. While holding the motor bracket inside the
electronics compartment, connect the motor cable to the motor.
2. Lower the motor bracket until the upper screw holes in the bulkhead are aligned
with the upper pem nuts in the motor bracket.
3. While holding the motor bracket in position, install, but do not tighten, two M3 x 8
mm pan head Phillips sems screws in the upper screw holes.
100
Door Opener/Magazine Lock Assembly
Chapter 6 - Parts Removal and Replacement