Figure 2-16 Base Module Default; Figure 2-17 Base Module Main; Figure 2-18 Configure Submenu; Figure 2-19 Configure Submenu - Overland Data DLT LibraryXpress Series Service Manual

2. Press the
Enter
3. Press the button three times to select the Configure Menu, then press the
The screen shown in Figure 2-18 appears.
4. Press the button repeatedly to select Set Special Configuration, as shown in Figure 2-
19.
5. Press the
Enter
Chapter 2 - Installation
DLT1 Idle
DLT2 Idle
Loader Idle
1
_ _ _ _ _ _ _ _
Figure 2-16 Base Module Default Screen
button to display the Main Menu, shown in Figure 2-17.
oad/Unload
L
Show Status Menu
Maintenance Menu
Configure Menu
Figure 2-17 Base Module Main Menu
Set Data Format
Set SCSI
Set Element Base
Set Identification
Figure 2-18 Configure Submenu
Set Serial Number
Set Unload Mode
Set Negotiation
Set Special Config
Figure 2-19 Configure Submenu, Scrolled
button. The screen shown in Figure 2-20 appears.
10
button.
Enter
35