Running the Cleaning Cartridge
This procedure assumes that the cleaning cartridge has been installed into Slot 1 of the
system.
1.
On the control panel of the Global Control Module, at the Default Screen, press the
button. The display will show the following.
Enter
Press the θ button twice to move the
2.
button to select the Maintenance Menu. The display will show something
Enter
similar to the following.
3.
Press the
4.
Lines 2 and 4 are scrollable. The choices available on Line 2 are DLT1 through
DLTn. Let us assume you want to clean DLT1. Press the
accept DLT1. The
use the cartridge in Slot 1. Note: If you are unable to use slot 1 for the cleaning
cartridge, you can scroll line 4 to select another slot.
5.
The Clean Confirmation Screen appears, as shown below.
Chapter 4 - Maintenance
Load/Unload
Show Status Menu
Maintenance Menu
Configuration Menu
Figure 4-1
Clean Drive
Diagnostic Menu
Demo Menu
Flash Update
Figure 4-2
Maintenance Menu
button once to select Clean Drive., The following screen appears.
Enter
Cleaning:
DLT1
Using
Slot1
Figure 4-3
Cleaning Submenu
moves to line 4 of the display. Press the
Main Menu
next to 'Maintenance Menu', then press the
button once to
Enter
button again to
Enter
75