Figure 2-1. Xpresschannel External Parts - Overland Data DLT LibraryXpress Series Service Manual

Note: The slide extensions, (6) in Figure 2-1, are not enclosed with the XpressChannel parts.
They are supplied as part of the installation hardware for the slides that come with each of the
modules.
Follow the instructions for installing rack slides, later in this chapter. After the rack slides and
the slave modules are in place, and after the XpressChannel is assembled, you will install the
XpressChannel in the rack by attaching the support braces (5) to the slide extensions (6) using
the angle brackets (7) and L-shaped nut plates (8).
The internal parts you will need to recognize during assembly are shown in Figures 2-2 and 2-
3.
•
Car
•
Belt Block
Chapter 2 - Installation
Figure 2-1. XpressChannel External Parts
15