Drive Caddy Assembly (Base Module Only); Figure 6-4 Bar Code Reader - Overland Data DLT LibraryXpress Series Service Manual

Replacement
Refer to Figure 6-4.
1. Position the Bar Code Reader against the front of the Shuttle Assembly. The cable
should be at the top left of the Bar Code Reader.
2. Install two M4 x 8 mm mounting screws.
3. Plug the cable into the connector on the shuttle to the left of the reader.
4. Install the cover plate as described in this chapter.

Drive Caddy Assembly (Base Module Only)

The Drive Caddy Assembly is an enclosure that holds one or two DLT drives and their
associated cabling. It includes the SCSI interface connectors and cables for the Base Module,
the power cables for the drives, and communications cables from the drives to the Controller
PWB. The Drive Caddy Assembly must be removed to gain access to the DLT drives, the
SCSI cabling, and to the fan.
Removal
Important Note: To avoid breaking the door levers when lifting the drive caddy out of the
chassis, take the following precautions: a) when you begin pulling upward on the caddy
handle, steady the caddy so it cannot rock forward as it clears the platform, and b) take care
not to allow the door levers to touch the strut across the top of the chassis.
92
Figure 6-4 Bar Code Reader
Chapter 6 - Parts Removal and Replacement