Table of Contents
Advertisement
Multiplexer Assembly
Figure 6-18
Removal
Refer to Figure 6-18.
1.
Remove the cover plate as described in this chapter.
2.
Disconnect the two ribbon cables at the multiplexer PWB.
3.
Remove sixteen 4-40 jackscrew sockets and split lock washers that hold the eight
connectors to the back of the chassis.
4.
Remove the Multiplexer PWB from the chassis.
Chapter 6 - Parts Removal and Replacement
Multiplexer Assembly (Global Control Module Only)
113
Advertisement
Table of Contents
Troubleshooting
