Figure 6-6 Control Panel - Overland Data DLT LibraryXpress Series Service Manual

Replacement
Refer to Figure 6-6.
1. Position the control Panel behind the four standoffs at the rear of the Front Panel.
2. Install four M3 x 10 mm pan head Phillips sems screws, one in each standoff, that
hold the Control Panel to the Front Panel. Do not overtighten.
3. At the Control Panel end, plug in the cable that connects the Control Panel to the
Controller Assembly PWB.
4. Install the Door Opener/Magazine Lock Assembly as described in this chapter.
5. Install the Power Supply Assembly as described in this chapter.
6. Install the cover plate as described in this chapter.
Chapter 6 - Parts Removal and Replacement
Figure 6-6 Control Panel
95