A Configuration Example - Setting The Scsi Id; Figure 2-20 Special Configs; Figure 2-21 Special Configs; Figure 2-22 Acknowledgment - Overland Data DLT LibraryXpress Series Service Manual

6. Press the button repeatedly to scroll down to select Alternate Config, as shown in
Figure 2-21.
Figure 2-21
7. Press the button to move the cursor to the fourth line. Press the
the fourth line to 'Slave.' The screen shown in Figure 2-22 appears.
Press the button. When the Special Configuration Submenu reappears, turn the power
Enter
switch off.

A Configuration Example - Setting the SCSI ID

1. Turn the system on*, and wait until the Power-On Self Test terminates and the
default screen appears on the display. Figure 2-23 shows a typical default screen.
Yours may vary depending on the number of modules in your system, as shown in
the second line.
*see the section titled 'Starting the DLT Library System' in Chapter 3 - Operation.
36
Mode Page 1F Length
*Short 0x0E
Model Number:
*OVERLAND LX-----
Figure 2-20 Special Config Submenu
Unit Attn. Report:
*All:
Alternate Config:
*Standalone
Special Config Submenu, Scrolled
Change Not Effective
Until Reboot
ENTER to Continue
Figure 2-22 Acknowledgment Screen
button to change
Enter
Chapter 2 - Installation