Parts Locations - Overland Data DLT LibraryXpress Series Service Manual

Tools that may be necessary to service the LibraryXpress system are listed below.
Straight Blade Screwdriver
#1, #2 Phillips screwdrivers
7 mm Socket Wrench
7 mm, 10 mm, 11 mm and 15 mm open end
wrenches
M3 and M4 Nut Drivers
Loctite 222
Important Note: All screws that do not use lock washers, captive washers or lock nuts must
have Loctite 222 applied when reassembled in the field. Neglecting this step may result in
premature failure of the mechanism.
Note: Some parts within the module have been assembled using Loctite. Extra torque may be
required to remove those screws. Be careful not to strip the screw. In most FRU kits spare
screws are included.

Parts Locations

Figure 6-1 shows the locations of most of the field-replaceable parts of the Base Module.
Figure 6-2 shows those of the Global Control Module and the Capacity Module.
86
TOOLS
Pliers
#1, #2 Phillips stubby screwdriver
5/16" and 7/16" open end wrenches
7/32 nut driver
Flush Diagonal Cutting or End Cutting Pliers
Chapter 6 - Parts Removal and Replacement