Figure 3-5 Initialization Screen - Overland Data DLT LibraryXpress Series Service Manual

Initialization Screens
After the POST is completed, the library robotics system is initialized. A series of screens
similar to Figure 3-5 is displayed during this process.
Default Screen
After the POST diagnostics have concluded successfully and initialization is complete, the
system default screen appears, as shown in Figure 3-6.
The numbers on the second line correspond to the slave modules that are connected to the
system. Up to eight slave modules may be connected. The third and fourth lines represent the
cartridge magazine in the Global Control Module. A rectangle will appear in each position
which contains a cartridge. An underline represents an empty slot.
Fault Screen
When a fault is detected within the Global Control Module or the XpressChannel, a screen
similar to Figure 3-7 appears.
When a fault is detected in one of the slave modules, the Alert LED on the Global Control
Module control panel is illuminated. The Fault Screen appears on the malfunctioning slave
module. At the same time, either the Drive Fault or the Loader Fault LED is illuminated on
that module.
Chapter 3 - Operation
OVERLAND LXG
Firmware Level 0X.xx
Initializing Loader
26-Feb-19xx 15:35:59
Figure 3-5 Initialization Screen
READY
Modules 123456
__
1
11 16
Figure 3-6 Default Screen
Fault Code: XXXX
Error Description
ERP line 1
ERP line 2
Figure 3-7 Fault Screen
10
51