Figure 3-28 Load /Unload 'T O ' E; Figure 3-29 Confirmation Screen - Overland Data DLT LibraryXpress Series Service Manual

Figure 3-27
When you have scrolled to your desired source, press the
in Figure 3-28, two changes occur in the display.
•
The reappears at the beginning of line 2, indicating that you have made a selection.
•
The now moves to line 4, indicating that you may now select a destination.
You can now simply press the
is no at the end of line 4, nor
because 1) you have selected a slot as the source, so the destination must be a drive, and 2)
DLT2 already has a cartridge in it, so it cannot be a valid destination. Press the
to select DLT1. In response, the confirmation screen in Figure 3-29 appears.
As the confirmation screen indicates, to execute the load or unload, press the
the confirmation screen does not show your intended source and destination, press the
button to return to the 'From' entry screen.
When you press the
drive, the word 'Unload' appears in place of the word 'Load' on line 4.
64
From:
Slot4
To:
DLT1
Load/Unload 'From' Entry Screen
From:
Slot4
To:
DLT1
Figure 3-28 Load/Unload 'To' Entry Screen
button to select DLT1 as the destination. Note that there
Enter
at the end of line 1. There are no additional choices
From: Slot4 To:DLT1
ENTER To Execute
ESCAPE To Cancel
Figure 3-29 Confirmation Screen
button, the screen shown in Figure 3-30 appears. If the source is a
Enter
button to select it. Notice that
Enter
Enter
Enter
Chapter 3 - Operation
button
button. If
Escape