Interface Cable And Terminator Installation; Figure 2-14 Base Module Scsi Connectors, Terminators And Cables; Figure 2-15 Base Module Scsi C - Overland Data DLT LibraryXpress Series Service Manual

Interface Cable and Terminator Installation

Figure 2-14
(Fast/Wide Interface, Independent Bus Connection Shown)
Figure 2-15 Base Module SCSI Connectors, Terminator, Jumpers and Cables
(SCSI-2 Interface, Daisy-chained Connection Shown)
To properly cable a module:
1. Make sure that your host system has an appropriate SCSI interface card for each
SCSI bus and software drivers installed.
2. Inspect the terminator and make sure whether it is a single-ended or differential
type, to match your system. SCSI terminators should be clearly marked "single-
ended" or "differential".
Chapter 2 - Installation
Base Module SCSI Connectors, Terminators and Cables
33