Mounting The Module Rack Slides - Overland Data DLT LibraryXpress Series Service Manual

8. Referring to Figure 2-1 and 2-4, remove the eight screws holding a pair of tie bars in
place. Separate the XpressChannel at that joint.
9. You may now add sections as needed and install a new belt as described in the
sections entitled 'Assembling the XpressChannel' and 'Installing the Belt.'

Mounting the Module Rack Slides

At this point, it is necessary to install the rack slides for all of the modules in order to
complete installation of the XpressChannel. Follow the directions in the shipping container to
unpack each of the modules and place them in the desired physical location. Save the packing
materials for re-use in case you need to send the module to Overland Data for repairs.
Note: The cooling grilles at the rear of the modules must not be obstructed when the modules
are installed in the rack. It is advisable to allow two inches of clearance behind the rear panel
of the module.
Make certain that when the module is fully extended that a
force of 20% of the rack weight, but not more than 57 lb.
applied in any direction but upwards does not cause the rack
Bitte beachten, daß wahrend das Module ausgezogen sind,
Gestallgewichtes, aber nicht mehr als 26 KG in alle
richtungen außer nach oben, die Stabilität des Gestalls nicht
Note: All of the screws, washers and nut plates required for rack mounting are supplied with
each module. The slides must be fastened to the front rails of the rack using four stainless
steel 10-32 low-profile screws and the nut plates provided. Two 10-32 clip nuts are provided
to engage the captive screws on the front panel.
Follow the instructions below to install each LibraryXpress Module into the rack. You will
need a #2 Phillips screwdriver and a flathead screwdriver. Refer to the figures as directed.
Note: The left and right slides are alike, so there is no risk of confusing the parts on assembly.
24
CAUTION!
to overbalance.
VORSICHT:
lediglich eine zusätzliche Last von 20% des
gefährdet.
Chapter 2 - Installation