Shuttle Motor Assembly; Figure 6-21 Shuttle Motor - Overland Data DLT LibraryXpress Series Service Manual

Shuttle Motor Assembly

Removal
Refer to Figure 6-21.
1. Remove the cover plate as described in this chapter.
2. If the belt is to be replaced, remove the Leadscrew Assembly as described in this
chapter. Otherwise, skip this step.
3. Disconnect the motor cable at the shuttle motor.
4. While supporting the shuttle motor, remove two M3 x 8 mm pan head Phillips sems
screws that hold the motor mounting bracket to the chassis.
5. Disengage the motor from the belt, and lift the motor clear of the chassis.
Replacement
Refer to Figure 6-21.
1. Position the motor inside the chassis near where it is to be installed. Orient the
motor so that the connector is down. Place the motor pulley inside the belt.
2. While supporting the motor, loosely install two M3 x 8 mm pan head Phillips sems
screws through slotted holes in the rear of the chassis into pem nuts on the motor
mounting bracket.
3. If it has been removed, replace the Leadscrew Assembly as described in this
chapter.
4. While applying moderate pressure to the motor so as to tighten the belt, tighten the
two screws.
120
Figure 6-21 Shuttle Motor
Chapter 6 - Parts Removal and Replacement