Removing The Cleaning Cartridge; Figure 4-4 Cleaning Confirmation; Figure 4-5 Cleaning I N Progress - Overland Data DLT LibraryXpress Series Service Manual

6. As the confirmation screen indicates, to execute the cleaning operation, press the
button. If the confirmation screen does not show your intended drive and
Enter
cleaning cartridge, press the
When you press the
When the cleaning operation is completed, the Default Screen reappears.

Removing the Cleaning Cartridge

This section assumes that the cleaning cartridge is in slot 1, which is in the Global Control
Module.
1. Examine the Default Screens on the control panels of the Base Modules to
determine whether any cartridges are loaded into the drives. If so, then unload each
as described in Chapter 3 - Operation in the section titled 'Loading and Unloading
Tapes.'
2. Remove the magazine from the Global Control Module using the procedure
described in Chapter 3 - Operation, in the section titled 'Inserting and Removing
Cartridges.'
3. Remove the cleaning cartridge from Slot 1 (the slot nearest the handle).
4. Insert any desired cartridge into Slot 1.
5. Press the
6. Insert the magazine into the module. If you want to lock the magazine, perform step
7. Otherwise, this completes the operation.
7. On the control panel of the Global Control Module, select 'Security Menu' on the
Main Menu, then 'Lock All Media' on the Security Menu. Note: Modules may be
unlocked and locked individually using the individual module locking items on the
Security Menu.
All media are now locked.
76
Clean:
Use:
ENTER To Execute
ESCAPE To Cancel
Figure 4-4 Cleaning Confirmation Screen
Escape
button, the In Progress screen appears.
Enter
Clean:
Use:
Cleaning In Progress
Figure 4-5 Cleaning In Progress Screen
button on the front panel of the Global Control Module.
Unlock/Open
DLT1
Slot1
button to return to the Cleaning submenu.
DLT1
Slot10
Chapter 4 - Maintenance