Switch Test - Chrysler Concorde 1993 Service Manual

8R - 2 POWER SEATS
Fig. 2 Switch Removal

SWITCH TEST

(1) Remove switch from mounting position (Fig. 2).
(2) Using an ohmmeter, perform the switch conti-
nuity tests in Fig. 3. If there is no continuity at any
of the switch positions, replace switch.
SWITCH REPLACEMENT REMOVAL
(1) Remove left cushion side shield (Fig. 2).
(2) Disconnect wiring from switch.
(3) Depress bezel retainers and push switch from
bezel.
(4) For installation, reverse above procedure.
SEAT ASSEMBLY REMOVAL
(1) Remove adjuster attaching bolts and nuts from
floor pan. Move adjuster as required for access.
(2) Disconnect battery negative cable.
(3) Disconnect wiring harness power lead at car-
pet.
(4) Remove assembly from vehicle.
(5) For installation, reverse above procedure. In-
stall and torque mounting bolts and nuts to 28 N¼m
(250 in. lbs.). Connect the battery negative cable and
check seat operation.
Fig. 3 Seat Switch Test