Chrysler Concorde 1993 Service Manual page 275

Column Shift Interlock Service
Floor Shift Interlock Adjustment
Floor Shift Interlock Service . . . . . . . . . . . . . . . . . 20
General Information . . . . . . . . . . . . . . . . . . . . . . . 17
GENERAL INFORMATION
LH vehicles have an interlock system. The system
prevents shifting the vehicle out of Park unless the
ignition lock cylinder is in the Off, Run or Start po-
sition (Fig. 1 or Fig. 2). In addition, the operator can-
not rotate the key to the lock position unless the
shifter is in the park position.
Fig. 1 Ignition Interlock—Floor Shift
Fig. 2 Ignition Interlock—Column Shift
IGNITION SWITCH
The ignition switch attaches to the lock cylinder
housing on the end opposite the lock cylinder (Fig.
IGNITION SWITCH AND INTERLOCK
INDEX
page
. . . . . . . . . . . . . . . 19
. . . . . . . . . . . . . . 21
IGNITION SYSTEMS
Ignition Interlock . . . . . . . . . . . . . . . . . . . . . . . . . 19
Ignition Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Lock Cylinder Housing . . . . . . . . . . . . . . . . . . . . . 22
Lock Key Cylinder . . . . . . . . . . . . . . . . . . . . . . . . 18
3). For ignition switch terminal and circuit identifi-
cation, refer to Group 8W, Wiring Diagrams.
Fig. 3 Ignition Switch
REMOVAL
(1) Disconnect the negative cable from the battery.
(2) Remove the tilt lever attaching screw. Remove
lever.
(3) Remove the upper and lower cover from steer-
ing column.
(4) Disconnect electrical connector from ignition
switch (Fig. 4).
(5) Remove Ignition switch mounting screws. Re-
move switch.
INSTALLATION
(1) A tab on the ignition switch indexes to a notch
in the lock cylinder housing (Fig. 5). Also, a slot in
the end of the ignition switch fits over the shaft in
the end of the lock cylinder housing. Use the ignition
key to rotate the lock cylinder to align the ignition
switch with lock cylinder housing.
(2) Install and tighten ignition switch mounting
screws.
(3) Attach electrical connector to ignition switch.
(4) Install tilt lever.
(5) Install upper and lower cover on steering col-
umn.
(6) Connect negative cable to battery.
8D - 17
page